VAG MG1 Bench Harness for Bosch MG1 ECUs

VAG MG1 bench harness for easier connections

The VAG MG1 bench harness gives you a straightforward, plug-and-play way to connect your AutoTuner tool to supported Bosch MG1 ECUs. Spend less time tracing pins and preparing wires, and more time getting on with the job.

Manual bench wiring can be fiddly and leaves room for connection mistakes or accidental pin damage. This purpose-built harness simplifies setup, helping you work with greater confidence and keep your workshop bench workflow moving.

Connect the harness to your AutoTuner tool and compatible ECU as directed, then get started. It’s a practical choice for technicians and workshops that regularly work with supported VAG controllers in bench mode.

Key highlights

• Provides a plug-and-play connection between an AutoTuner tool and a supported ECU
• Helps reduce setup time compared with locating pins and wiring connections manually
• Simplifies bench connections and helps reduce the risk of wiring errors or pin damage
• Compatible with Bosch MG1CS002, MG1CS008, MG1CP007, MG1CS038, MG1CS047, MG1CS202, MG1CS203 and MG1CP994 controllers

Make your next supported VAG MG1 bench setup simpler with a harness designed to get you connected with less fuss.